Properties of Bulk Matter
Test set 1
Full marks: 40
Time: 10 Minutes
Each right answer contains +4 and Wrong answer -1 marks.
1.
The bulk modulus of a spherical object is B. If it is subjected to uniform pressure p, the fractional decrease in radius is NEET 2017
p/3B
2.
When a weight of 10 kg is suspended from a copper wire of length 3 m and diameter 0.4 mm, its length increases by 2.4 cm. If the diameter of the wire is doubled, then the extension in its length will be: AIPMT 2010
4.8 cm
3.
A rubber cord catapult has cross-sectional area 25 mm2 and initial length of rubber cord is 10 cm. It is stretched to 5 cm and then released to project a missile of mass 5 gm. Taking Yrubber =5×108 N/m2 velocity of projected missile is: CPMT 2002
250 m/s
4.
The units of Young’s modulus of elasticity are: CPMT 2000
N-m2
5.
When a certain weight is suspended from a long uniform wire, its length increases by one cm. If the same weight is suspended from another wire of the same material and length but having a diameter half of the first one then the increase in length will be: CPMT 1984, 90
4 cm
6.
The following four wires are made of same material. Which of these will have the largest extension when the same tension is applied? NEET 2013
Length = 100 cm, diameter = 1mm
7.
Two similar wires under the same load yield elongation of 0.1 mm and 0.05 mm respectively. If the area of cross-section of the first wire is 4 mm2, then the area of cross-section of the second wire is: CPMT 2000
8 mm2
8.
A capillary tube of radius r is immersed in water and water rises in it to a height h. The mass of the water in the capillary is 5 g. Another capillary tube of radius 2r is immersed in water. The mass of water that will rise in this tube is: NEET 2020
20.0 g
9.
Copper of fixed volume V is drawn into wire of length l. When this wire is subjected to a constant force F, the extension produced in the wire is ∆l. Which of the following graphs is a straight line? AIPMT 2014
∆l versus l
10.
Two wires are made of the same material and have the same volume. The first wire has cross-sectional area A and the second wire has cross-sectional area 3A. If the length of the first wire is increased by ∆l on applying a force F, how much force is needed to stretch the second wire by the same amount? NEET 2018
9 F
Score
